Snapper Snow Blower 2 9693 User Manual

ELECTRIC START SYSTEM DEALER SET-UP INSTRUCTIONS for  
SNAPPER LARGE FRAME SNOW THROWERS  
INTRODUCTION: It will be necessary to complete Dealer Set-Up Instruction #2-8224 first before attempting to  
install the electrical components described in this Electric Start System Dealer Set-Up Instruction.  
WARNING: Always disconnect spark plug wire from spark plug before performing maintenance on snow  
thrower. DO NOT operate snow thrower without guards in place. DO NOT put hands into areas that house  
rotating parts while machine is in operation!  
STEP 1: Drill two 5/16 diameter holes in right side of  
auger housing using dimensions shown. See Figure 1.  
LIGHT  
5/16 DIAMETER  
HOLES  
AUGER  
HOUSING  
TIE  
LIGHT WIRE  
HARNESS  
3-7/16”  
4”  
4-5/16”  
TIE  
FIGURE 1  
STEP 2: Drill two 5/16 diameter holes in control panel  
within the 5” by 7” boundary lines shown. Drill holes  
using dimensions shown. See Figure 2.  
FIGURE 3  
STEP 4: Remove battery mounting bracket and battery  
clamp from #6-0651 Battery Mounting Kit and assemble  
these parts as shown. See Figure 4.  
BOUNDARY  
LINES  
BATTERY CLAMP  
CONTROL  
PANEL  
BATTERY MOUNTING  
BRACKET  
5”  
5-3/4”  
7”  
5/16 DIAMETER  
HOLES  
BEND TAB OVER  
FIGURE 2  
FIGURE 4  
STEP 3: Install light onto control panel with washer and  
nut and tighten securely. Install light wire harness into  
end of light wire and route down handle and secure with  
ties as shown. See Figure 3.  
INSTRUCTION #2-9693 (I.R. 8/94)  
 

Sennheiser Stereo Receiver EM 1005 90 User Manual
Sharp All in One Printer TINSE4377FCZZ User Manual
Sharper Image Thermostat OQ234 User Manual
Silva Boating Equipment 70p User Manual
Singer Sewing Machine 11W8 User Manual
Sony Cell Phone D5102 D5103 D5106 User Manual
Sony Clock Radio ICFCD3iPSIL User Manual
Sony Speaker XS V6933 User Manual
Sony TV Video Accessories HMZT3W User Manual
Sunbeam Espresso Maker EM3600 User Manual